Glock Trigger Mechanism Housing Bent

Glock Trigger Mechanism Housing Bent. Buy premium quality glock trigger housing with spring assembly for your glock pistols. I originally thought it was an issue with the slide release but the slide notch had cleared the release.

CONNECTOR INSTALLATION INSTRUCTIONS Ghost Inc from ghostinc.com

Fits g20sf, g21sf, g30sf, g29sf, g21gen4, and g20gen4 only. Trigger mechanism housing w/ejector and spring glock 42/43/43x & 48. I recommend that you dismantle the pistol, separate the trigger bar from the trigger mechanism housing, remove the connector, and show us a good photo of the right side of the trigger.

Source: ghostinc.com

Do this until you really get a feel for the trigger pull and how. If that connector got bent and doesn't stick out, i would imagine that would lead to some pretty strange problems.

Source: looserounds.com

Then you can slowly press the trigger again until you feel the resistance and you fire again. From firing pins to trigger springs, nothing keeps your glock running like oem parts.

Case Contains Spare Firing Pins & Trigger Springs, Stock Wrench, Cloth Covers & Owners Manuals.

This is what you want to pay attention to. Visit our vast inventory of custom parts and other glock accessories. This is the leaf spring mechanism not the past s trigger spring.

I Was Cleaning Them Today When I Noticed That The Little Metal Prong Thing On The Trigger Mechnisim Housing Looked Bent On The 17.

Or the trigger mechanism housing may be defective. I originally thought it was an issue with the slide release but the slide notch had cleared the release. This is done by sliding a.

Or The Trigger Bar May Be Defective Or Bent.

Lop w/ trigger in rear position: To solve the problem, i tuned the connector by bending it back towards the housing. To eject the 22lr case properly, the tip of the 33850 ejector must have the inward angle shown in the picture so it strikes the base of the case at about the 7:00 o'clock position.

Once It Is Started, Use The Flat Head Of Your Glock Certified Armorer 8 Penny Nail To Drive The Pin Flush With The Frame.

It is the short pin in the gen4 set. Glock trigger mechanism housing w/ 336 ejector, 9mm &.380 (excludes gen4, gen5, g19x, g45, g45 mos) $8.50. I recommend that you dismantle the pistol, separate the trigger bar from the trigger mechanism housing, remove the connector, and show us a good photo of the right side of the trigger.

Glock Trigger Housing Pin, Part #30 On The Glock Schematic, Is Used In All Gen3 Glocks As Well As The Gen4 Glock Without The Additional Back Straps.

I unloaded the gun, stripped it, and found out that the metal piece that sticks out at the top of the trigger mechanism housing was bent and i guess preventing the round from chambering thus, holding my slide open. When you press the connector into the housing ensure that bottom portion that is mounted in the trigger mechanism housing sits slightly below flush in the trigger mechanism housing. Reinstall the trigger coil spring on the trigger with bar.

Share :